Stepper Motor 28BYJ-48 Controller pcb

This is a simple pcb to move a 28BYJ-48 stepper motor using a microcontroller (ATMega8 or ATMega328) and a ULN2003.

There is a P-mosfet on board to be able to turn on or off the stepper motor. A resistor in parallel with the mosfet (R3 or R6) reduces the standby current without turning it off and avoid losing steps.

I designed it specifically to run holo clock. An amazing 3d printed clock you can find here.

Enter your email to receive the gerber files for the pcb. BOM available here.

Downloads: 12

    Leave a Reply

    Your email address will not be published. Required fields are marked *